Surface Textures Fabricated by Laser Surface Texturing and Diamond Cutting - Influence of Texture Depth on Friction and Wear

doi:10.1002/adem.201700995

CIOMP OpenIR

	Surface Textures Fabricated by Laser Surface Texturing and Diamond Cutting - Influence of Texture Depth on Friction and Wear
	Zhang, J. J.; Zhang, J. G.; Rosenkranz, A.; Zhao, X. L.; Song, Y. L.
	2018
发表期刊	Advanced Engineering Materials
ISSN	1438-1656
卷号	20 期号:4 页码:8
摘要	In the present work, the authors study the tribological characteristics of textured stainless steel surfaces with different texture depths ranging from 1.3 to 23 mu m created by laser surface texturing and ultra-precision diamond cutting. The periodicity of the surface textures is kept constant at 90 mu m for each fabrication technique and texture depth. Subsequent ball-on-disk friction tests show that friction and wear can be effectively reduced by the surface texturing. It is found that the effectiveness of the surface textures greatly depends on the depth and the geometry of the textures, as well as on testing parameters such as the applied load and the sliding velocity. Surface textures with the lowest depth demonstrate a slightly increased COF as well as an increased mass loss under low loads or sliding velocities. On the other hand, surface textures with intermediate depths show a significant reduction in the COF and wear. The observed friction and wear reduction can be mainly attributed to a combined effect of the surface textures consisting of the generation of an additional hydrodynamic pressure, the storage of produced wear particles as well as the action as secondary source for lubricant (reservoir effect).
关键词	damond cutting friction reduction laser texturing surface texturing texture depth tribological behavior steel reduction microstructures vibration optimization performance alignment Materials Science
DOI	10.1002/adem.201700995
收录类别	SCI ; EI
引用统计	被引频次：38[WOS] [WOS记录] [WOS相关记录]
文献类型	期刊论文
条目标识符	http://ir.ciomp.ac.cn/handle/181722/61169
专题	中国科学院长春光学精密机械与物理研究所
推荐引用方式 GB/T 7714	Zhang, J. J.,Zhang, J. G.,Rosenkranz, A.,et al. Surface Textures Fabricated by Laser Surface Texturing and Diamond Cutting - Influence of Texture Depth on Friction and Wear[J]. Advanced Engineering Materials,2018,20(4):8.
APA	Zhang, J. J.,Zhang, J. G.,Rosenkranz, A.,Zhao, X. L.,&Song, Y. L..(2018).Surface Textures Fabricated by Laser Surface Texturing and Diamond Cutting - Influence of Texture Depth on Friction and Wear.Advanced Engineering Materials,20(4),8.
MLA	Zhang, J. J.,et al."Surface Textures Fabricated by Laser Surface Texturing and Diamond Cutting - Influence of Texture Depth on Friction and Wear".Advanced Engineering Materials 20.4(2018):8.

条目包含的文件		下载所有文件
文件名称/大小	文献类型	版本类型	开放类型	使用许可
Surface Textures Fab（1739KB）	期刊论文	出版稿	开放获取	CC BY-NC-SA	浏览下载